FLUENTPOWER 3/4HP Sump Pump 3600GPH Stainless Steel Submersible Pump, Drain Clean/Dirty Water for Basement Flood Cellar Pool Pond Garden Hot Tub, Automatic/Continuous Manual Operation by Float Switch. 60 Gallons Per Minute. Empty water from unwanted place. 15.75 x 7.08 x 9.44 inches. 3/4 HP HIGH EFFICIENCY? Equipped with 3/4 HP powerful motor, the capacity of transferring water can be Max. 3600 GPH with 1.5 discharge hose horizontally. Pump has the ability to lift water up to Max. 27 ft vertical, 2500 gallons per hour on at 10 ft discharge lift. This sump pump works with clean and dirty water which contains solid less than 1.4. FULL STAINLESS STEEL CASING? Assembled by integrated 304 stainless steel housing and pump base with better cooling ability for long life. Pump also comes with a 26.2 ft long cable cord, which allows pump to go deep enough (23 ft) in the water. This pump can be used in Min 16″x16″ pit. SAFETY ENSURE & DURABLE? Upgraded Sealing Structure gives pump longer life time, which is much longer than regular mechanical seal. Full corrosion-resistant shell and thermal protection ensures the pump will not be burned out, even when the pump trigger thermal overload protector, pump will rework after cooling down. The pump ON/OFF is controlled by float switch. Once the water pump is plugged in, it will automatically start when the water level is above 15-20″, and stop working when reaching the stop-level of 6″. When you start to use this pump, tilt and submerge the pump into water for a few seconds to expel the air inside of the pump. For the customers who don’t like to use the float switch, you can just simply attach it on its side slot, so that the pump becomes manually controlled. This can be used when water level is low and not enough for floater freely floating in the water. Pump can remove water down to 2, and it will keep continuously running and will not turn off automatically, so remember to cut off the power immediately to prevent the motor become burned! Comes with three plastic adapters: GHT 3/4″, NPT 1″ and 1.5 male tread connectors. GHT 3/4″+NPT 1″ connects standard garden hose for quickly installation. 1.5 male tread connects discharge hose for maximum output flow rate, this adapter has three different diameters outlets (Diameter 1 inch, 1-1/4 inch, 1-1/2 inch) to adapt for different size hoses as needed. The bigger the flow is, the wider the outlet should be. This pump is designed for multi applications and emergency use, like flooding basement, garden pond, hot tub, and so on. Provide lifelong technical consultation and 24h customer service. Min Water Level for Auto Start. Minimum Water Level for Float Switch Automatically Starts from. If the water level is not enough, you need to hang up the float to the “ON” position and make it manually controlled. Just be careful to dry running with this mode. Min Residual Water Level for Manual Mode. Pump water down to. By Manual Mode, and 6 by Auto Mode. If the water level is not enough, you can choose manual control. The maximum output with. We always suggest to use biggest discharge port and larger hose in order to have optimum performance! The pump is designed also to work with dirty water. Its Maximum solid passage is. So it will be suitable for mostly water conditions for your daily domestic application. Small sand, some muddy water, or particle all can pass through the pump. Don’t use the pump for any. Salt water, chemical or acid liquid. It may reduce the lifetime of pump. It’s better to have a sump or tank size. So that the float switch can be freely float in the water. The distance between the float switch and the pump should not be too small since the switch should be able to move freely. Also make sure that the float switch does not touch the floor. Setting ON/OFF Operating Point. The ON/OFF operating point of the pump can be readjusted by extending the cord of the float switch. Raise the float switch carefully and check if the pump switches on then lower it again to check if the pump switch off before pumping water. Transferring water from Rain Barrel for garden irrigation. Draining water from Garden Wells or Ponds. Removing water from the Flooding Areas. Pumping water from Hot Tub or Swimming Pool. GHT 3/4″, NPT 1″ and 1.5 male thread. GHT 3/4″ and 1.25″ male thread. We offer the best prices around on high quality products. Our E-store includes media such as books, movies, music and games while offering electronics, toys, sporting apparel, clothing, tools, general home, garden items and more. We are always working hard to ensure your package arrives as soon as possible. We do not accept P. Please provide a physical address. We try our very best to make sure every customer is completely satisfied. If there’s a problem, message us! We’re happy to help. This item is in the category “Home & Garden\Home Improvement\Plumbing & Fixtures\Pumps & Water Filtration Systems\Pumps”. The seller is “store-247sale” and is located in this country: US. This item can be shipped to United States.

• Brand: FLUENT TOOLS
• Item model number: FSP900DWB
• Style: 3/4HP
• Maximum Lifting Height: 26 Feet
• Maximum Flow Rate: 60 Gallons Per Minute
• Batteries Included?: No
• Usage: empty water from unwanted place
• Batteries Required?: No
• Power Source: ac
• Flow Rate: 60 Gallons Per Minute
• Product Dimensions: 15.75 x 7.08 x 9.44 inches
• Material: Stainless Steel, Plastic
• Item Dimensions LxWxH: 15.75 x 7.08 x 9.44 inches
• Is Discontinued By Manufacturer: No
• Manufacturer: FLUENT TOOLS
• Item Package Quantity: 1
• Item Weight: 8.6 Pounds
• Part Number: FSP900DWB
• Color: Black and Silver
• Wattage: 550 watts
• Voltage: 110 Volts
• Horse Power: 0.75 hp
• Size: 3/4HP
• Shipping :: Free and Fast US Shipping
• UPC: 726084516755
• EAN: 0726084516755